87
Recalling preset stations
• Recalling preset stations from the remote control unit.
• Preset stations can be chosen directry preset channel and channel
range button. (see page 52)
1
Watching the display, press the
SHIFT button to select the preset
memory block.
(Remote control unit)
2
Watching the display, press the
CHANNEL + (UP) or – (DOWN)
button to select the desired preset
channel.
(Remote control unit)
14
LAST FUNCTION MEMORY
• This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the
power is switched off.
This function eliminates the need to perform complicated resetting when the power is switched on.
• The unit is also equipped with a back-up memory. This function provides approximately one week of memory storage from when the main
unit’s power switch is off and with the power cord disconnected.
15
INITIALIZATION OF THE MICROPROCESSOR
When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the
microprocessor is required by the following procedure.
1
Switch off the unit using the main unit’s power operation
switch.
2
Hold the following PURE DIRECT button and DIRECT button,
and turn the main unit’s power operation switch on.
3
Check that the entire display is flashing with an interval of
about 1 second, and release your fingers from the 2 buttons
and the microprocessor will be initialized.
NOTES:
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the settings are reset
to the default values (the values set upon shipment from the
factory).
• Recalling preset stations from the main unit’s panel.
1
Press the TUNING PRESET button.
2
Turn the FUNCTION knob and
select the desired preset channel.
(Main unit)
(Main unit)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
