Getting Started Connections Playback Remote ControlZONE2 Information Troubleshooting Specifications
ENGLISH
n When using Surround Back Speakers
GExample qH GExample wH
The acoustic characteristics of the connected speakers and
listening room are measured and the optimum settings are made
automatically.
Audyssey Auto Setup Flown
a Connect the Included Setup Microphone
(vpage 28)
d Perform Audyssey Auto Setup (vpage 29)
s Audyssey Auto Setup Preparations
(vpage 29)
Change the Amplifier Assignment (Amp Assign)
(vpage 29)
Set the channel to be measured (Channel Select)
(vpage 29)
n
n
Check the Measuring Results and Equalizer
Type after Audyssey Auto Setup
(Parameter Check) (vpage 32)
Make the Optimal Speaker Settings, and Correct the Room Acoustics
(Audyssey™ Auto Setup)
Audyssey MultEQ
®
automatically measures the acoustical problems
in the listening environment to create the best audio experience for
your home theater.
• When Audyssey™ Auto Setup procedure is performed, the MultEQ
®
,
Dynamic EQ™ and Dynamic Volume™ functions (vpage 71, 72)
are enabled.
• Use the included setup microphone (DM-A409) to perform Audyssey
Auto Setup procedure.
• Measurements are performed by placing the calibrated microphone
successively at multiple positions throughout the listening area as
shown in GExample qH. For best results, it is strongly recommended
to measure 6 positions so that the measurements have the proper
spatial weighting.
Even if the listening environment is small as shown in GExample wH,
measuring at multiple points throughout the listening environment
results in more effective correction.
n When using Front Height Speakers
GExample qH GExample wH
FHL FL SW C FR FHR
SL SR
*
M
FHL FL SW C FR FHR
SL SR
*
M
( : Measuring positions)
Important Information
About the main listening position (*M)
The main listening position refers to the most central position where
one would normally sit within the listening environment.
MultEQ uses the measurements from this position to calculate
speaker distance, level, polarity, and the optimum crossover value
for the subwoofer.
FL :
Front speaker (L)
FR : Front speaker (R)
FHL : Front height speaker (L)
FHR : Front height speaker (R)
C : Center speaker
SW : Subwoofer
SL : Surround speaker (L)
SR : Surround speaker (R)
SBL : Surround back speaker (L)
SBR : Surround back speaker (R)
( : Measuring positions)
Settings
To Next Page
Loading...
Need help?
General
