EasyManuals Logo
Home>Denon>Stereo Receiver>AVR-990

Denon AVR-990 User Manual

Denon AVR-990
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image

Getting Started Connections Playback Remote ControlZONE2 Information Troubleshooting Specifications
ENGLISH
Make the Optimal Speaker Settings, and Correct the Room Acoustics (Audyssey Auto Setup)
Error Messages
When Performing Audyssey Auto Setup Over
Again
Press ui to select “Retry”, and then press ENTER.
When Measuring has Stopped
Press RETURN, the “Cancel auto setup?” prompt is displayed.
Press o p and select “Yes”, then press ENTER.
n
n
An error message is displayed if it was not possible to complete
Audyssey Auto Setup due to speaker placement, the measurement
environment, etc. If this happens, check the relevant items, be sure
to take the necessary measures, then perform Audyssey Auto Setup
procedure over again.
NOTE
Be sure to turn off the power before checking speaker connections.
Error messages (examples) Error contents
Measures
Included setup microphone is not connected.
Not all speakers could be detected.
The front L speaker was not properly detected.
Connect the included setup microphone to the
SETUP MIC jack of the AVR-990.
Check the speaker connections.
Too much noise in the room for accurate
measurements to be made.
Speaker or subwoofer sound is too low for
accurate measurements to be made.
Either turn off any device generating noise or
move it away.
Perform again when the surroundings are
quieter.
Check the speaker installation and the direction in
which the speakers are facing.
Adjust the subwoofer’s volume.
Displayed speaker could not be detected. Check the connections of the displayed speaker.
Displayed speaker connected with the polarities
reversed.
Check the polarities of the displayed speaker.
For some speakers, this error message may
be displayed even if the speaker is properly
connected. If you are sure the connection is
correct, press ui to select “Skip”, then press
ENTER.
Remote control operation
buttons
:Displaying the menu
Cancel the menu
:Moves the cursor
(Up/Down/Left/Right)
:Confirm the setting :Return to previous menu
Settings

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-990 and is the answer not in the manual?

Denon AVR-990 Specifications

General IconGeneral
BrandDenon
ModelAVR-990
CategoryStereo Receiver
LanguageEnglish

Related product manuals