Getting Started Connections Settings Remote ControlZONE2 Information Troubleshooting Specifications
ENGLISH
The channel switches continuously when [TUNING] is pressed and
held.
The song title, artist name, composer name, category and reception
level can be checked by pressing <STATUS>.
The time (default : 30 sec) for which the GUI menu are displayed can
be set “GUI” – “Tuner” (vpage 41). Press uio p to return to
the original screen.
•
•
•
1
Set [DEVICE SELECT 1] to “MAIN/TV” and [DEVICE
SELECT 2] to “MAIN”.
2
Press [SOURCE SELECT] to display the GUI Source
Select menu, then select “ ” (vpage 26).
3
Use [TUNING] to select the channel.
When the channel is tuned in, the name of the song and artist
are displayed.
4
Adjust the items below.
Adjusting the master volume (vpage 65)
Selecting the surround mode (vpage 67)
Adjusting the Sound and Picture Quality
(vpage 69)
n
n
n
Listening to SIRIUS Satellite Radio
The strength of both the SIRIUS satellite and terrestrial signals can be
checked “Antenna Aiming” (vpage 50).
Checking the SIRIUS Signal Strength and Radio ID
1
Press <STATUS> until “SIGNAL” appears on the
display.
The display will switch as shown below, depending on the
reception conditions.
Display Status
EXCELLENT Signal strength is excellent
GOOD Signal strength is good
WEAK Signal strength is weak
NO SIGNAL No signal
2
Adjust the position of the antenna until “SIGNAL:
EXCELLENT” is shown on the display.
3
Press <STATUS> until the channel (example:
“SR001”) is displayed.
4
Press [TUNING] and select channel 0 (SR000).
Channel No. and Sirius ID are alternately shown on the display.
S R 0 0 0 S i r i u s I D
* * * * * * * * * * * *
Write your own SIRIUS ID for storage use.
Sirius ID :
b
Sirius ID
When operating SIRIUS with the AVR-990 via the remote control unit,
use [SAT TU].
Tuning in Radio Stations – SIRIUS Satellite Radio
Presetting Radio Channels (Preset Memory)
Your favorite broadcast channels can be preset so that you can tune
them in easily. Up to 56 channels can be preset.
To preset other channels, repeat steps 1 to 4.
NOTE
Preset channels are erased by overwriting them.
Listening to Preset Channels
You can also operate via the main unit. In this case, perform the
following operations.
Press <TUNING PRESET>, then turn <SOURCE SELECT> to select the
preset radio channel.
Press [CHANNEL] to select the desired preset channel,
then press ENTER.
1
Tune in the broadcast channel you want to preset.
2
Press [MEMORY].
3
Press [SHIFT] to select the block in which the channel
is to be preset, then press [CHANNEL] to select the
preset number.
4
Press [MEMORY] again to complete the setting.
Playback
To Next Page
Loading...
Need help?
General
