8514-296-001 REV K page 56
4 MACHINE PROGRAMMING INSTRUCTIONS
The washer control can be programmed to prompt the user for alternate vend prices,
change washer cycle times, temperatures and many other options. This can be
accomplished in two ways:
1. Manual programming utilizing the “Start”, “Hot”, “Warm” and “Cold” buttons
2. USB download of a customizable User File. For instructions on using the USB
download feature, please contact your local Dexter distributor or visit
dexterlive.com.
4.1 MANUAL PROGRAMMING:
The washer must be in idle mode for the manual programming menus to be accessed.
Idle mode is when the washer is not actively running a wash cycle and the vend price is
displayed on the screen.
To enter the manual programming mode, the top of the washer must be unlocked and
lifted slightly (it may be necessary to remove the screws for the soap box). The
programming button is then pressed for 1 second. The control should display
“PROGRAMMING”.
See the figure below for the location of the programming button in relation to the USB
port (The USB port is exposed when the washer top is lifted).
To Next Page
Loading...
Need help?
General
