Dexter Laundry T-950 User Manual

8514-296-001 REV K page 75
5 DISPLAYED WASHER MESSAGES
Displayed
Fault Code Description
DOOR LOCK
ERROR
Door Lock
Error
Condition
This error is when the Door Locked signal
is not received within one second after the
start of the cycle. A fter three attempts to
start the washer.
Delay Immediate
Action
When the error occurs, the Door Lock
Motor will be turned off; all other outputs
will be turned off.
Solution
Check VFD fault light. Check to hear if door
motor engaged. Turn off the power to the
washer. Check wire connections to door
/lock switches. Check wire connections
from switches to controller. Check P-4
Door/Lock wire connections at PCB
controller. Adjust the door lock
mechanism. (See on line service manual
or video)
SLOW FILL
ERROR
Slow Fill Error Condition
This error is when a low water level is not
reach within 7 minutes.
Delay Immediate
Action The washer cycle will continue
Solution
Turn off the power to the washer. Check
the operation of the water valves. Check
the incoming water pressure. Check for
blocked or restricted water flow. Check to
ensure the drain valve is functioning
properly.
MEMORY ERROR
Checksum or
Out of Range
Condition
Memory error in the controller. The
memory checksum is wrong or a
parameter value is out of range.
Error Delay Immediate
Action
Stop the washer and turn off all the
outputs.
Solution
Check VFD fault light before turning off
power. Try a soft Reset of the controller
with the white button. If problem persist
replace PCB controller.
COMM ERROR1 I2C Bus Error Condition
Washer controller communication error on
the I2C bus. Both the main slave micro
and the master micro can be in this error
state. The slave micro error is recoverable
at any time, if I2C communication
resumes. The master micro error is
permanent.

Dexter Laundry T-950 Specifications

General

Brand	Dexter Laundry
Model	T-950
Category	Washer
Language	English