8514-296-001 REV K page 73
4.10 COIN WASHER DEFAULT CYCLE
The following table shows the complete details for the coin washer default
cycle.
Bath Bath Cycle
Time (min.)
Water
Temp.
Delay Fill Spin Time
(min.)
Prewash 0 Cold Off 0
Wash 9 Warm Off 0
Extend Wash 0 n/a n/a n/a
Rinse 4 Cold Off 1
Final Rinse 5 Cold Off n/a
Extra Rinse Spin n/a n/a n/a 0
Extra Rinse Bath 0 Cold Off n/a
Final Extract Spin
n/a n/a n/a 6
4.11 WASHERS WITHOUT COIN ACCEPTORS
If you purchased a washer without a coin acceptor and are installing a
payment device of your choice, refer to the washer wiring diagram for
proper connection. You may also need to contact the payment device
supplier for additional information.
4.12 RAPID ADVANCE MODE
Rapid Advance mode may be manually entered by pushing and holding
the Cold water temperature button and then pushing and holding the
programming button on the controller for three seconds. There will be no
observed change to the washer or the display. The Rapid Advance mode
can be entered from either the Idle mode or during the cycle. To rapid
advance to the next step in the wash cycle, push the start button. The
display will show “ADVANCE”. The washer will advance to the next bath
segment. The water will drain before the advance will occur.
The Rapid Advance mode will not end until the final bath segment is
completed. The final segment cannot be skipped in Rapid Advance
mode.
Notes: 1. When the Rapid Advance mode is used, the cycle time will no
longer be correct.
2. By skipping steps with rapid advance, the door may not open
immediately at the end of the cycle.
To Next Page
Loading...
Need help?
General
