EasyManuals Logo
Home>Digi>Control Unit>ConnectCore Series

Digi ConnectCore Series User Manual

Digi ConnectCore Series
151 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #116 background imageLoading...
Page #116 background image
ConnectCore for i.MX51
©2011DigiInternational,Inc. 116
The table below shows the GPIO signal assigned to the user interface, and the jumpers used
to enable/disable the buttons and LEDs:
Signal GPIO Jumper Comment
USER_BUTTON1 GPIO3_6 J28 10K pull-up to +2.775V on the development board
USER_LED1# GPIO3_10 J16
USER_BUTTON2 GPIO1_1 J29 10K pull-up to +2.775V on the development board
USER_LED2# GPIO3_9 J9

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Digi ConnectCore Series and is the answer not in the manual?

Digi ConnectCore Series Specifications

General IconGeneral
BrandDigi
ModelConnectCore Series
CategoryControl Unit
LanguageEnglish

Related product manuals