EasyManuals Logo
Home>Digi>Control Unit>ConnectCore Series

Digi ConnectCore Series User Manual

Digi ConnectCore Series
151 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #71 background imageLoading...
Page #71 background image
ConnectCore for i.MX51
©2011DigiInternational,Inc. 71
Camera Interfaces
The development board provides two camera interfaces connected to the camera sensor
interfaces of the ConnectCore for i.MX51 CPU. The I
2
C bus of the ConnectCore for i.MX51CPU
is used to configure and control the two cameras.
The I
2
C device addresses of the Digi camera application kits (CC-ACC0MT9V111) are the
following:
Interface I
2
C Address (7 bits)
Camera 1 0 x 5C
Camera 2 0 x 48
Camera 2
Connector, X17
Camera 1
Connector, X15

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Digi ConnectCore Series and is the answer not in the manual?

Digi ConnectCore Series Specifications

General IconGeneral
BrandDigi
ModelConnectCore Series
CategoryControl Unit
LanguageEnglish

Related product manuals