EasyManuals Logo
Home>Digi>Control Unit>ConnectCore

Digi ConnectCore User Manual

Digi ConnectCore
151 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #147 background imageLoading...
Page #147 background image
ConnectCore for i.MX51
©2011DigiInternational,Inc.. 147
module FCC ID. THis exterior label can use wording such as the following: “Contains
Transmitter Module FCC ID: MCQ-50M1699/ IC: 1846A-50M1699”.
RF Exposure
RF Exposure considerations require that a 20cm separation distance between users and the
installed antenna location shall be maintained at all times when the module is energized.
OEM installers must consider suitable module and antenna installation locations in order to
assure this in 20cm separation, and end users be also be advised to the requirement.
Modifications (FCC 15.21)
Changes or modifications to this equipment not expressly approved by Digi may void the
users authority to operate this equipment.
Industry Canada
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital
apparatus set out in the Radio Interference Regulations of the Canadian Department of
Communications.
Le present appareil numerique n’emet pas de bruits radioelectriques depassant les limites
applicables aux appareils numeriques de la class B prescrites dans le Reglement sur le
brouillage radioelectrique edicte par le ministere des Communications du Canada.
The maximum antenna gain permitted in the bands 5250-5350 MHz and 5470-5725 MHz to
comply with the e.i.r.p limit is, according to RSS-210 section A9.2(2)
250mW conducted power
1.0W max EIRP
This limit is met with the highest gain antenna listed, antennafactor ANT-DB1-RAF-RPS.
The maximum antenna gain permitted in the band 5725-5825 MHz to comply with the e.i.r.p
limit specified for non point-to-point operation is, according to RSS-210 section A9.2(3):
1W conducted power
4.0W max EIRP
This limit is met with the highest gain antenna listed,antennafactor ANT-DB1-RAF-RPS.
OEM installers and users are cautioned to take note that high-power radars are allocated as
primary users (meaning they have priority) of the bands 5250-5330 MHz and 5650-5850 MHz
and these radars could cause interference and /or damage to devices operating in these
frequency bands.
Downloaded from Elcodis.com electronic components distributor

Table of Contents

Other manuals for Digi ConnectCore

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Digi ConnectCore and is the answer not in the manual?

Digi ConnectCore Specifications

General IconGeneral
BrandDigi
ModelConnectCore
CategoryControl Unit
LanguageEnglish

Related product manuals