SYSTEM OVERVIEW
26 77091 Issue 2 November 2003
To open the ink compartment door, pull
open the door catch so that it disengages
with the rear of the base unit (as shown
right). The door can then be swung open
on its hinge allowing access to the interior.
To close the ink compartment door, reverse
this procedure. Hook the catch around the
fastening on the rear of the base unit and
press it in place. Take care not to trap the ink
and air lines when closing the door.
This photo shows the interior of the three
litre base’s door. The captive ink bottle cap
can be clearly seen hanging from its
connecting air and ink tubes. All the base
unit’s electronics are located behind the panel
in the door.
To Next Page
Loading...
Need help?
General
