PROGRAMMING AND PRINTING
56 77091 Issue 2 November 2003
The following screen will appear:
2 line LCD models:
Note: This screen presumes a printer capable of two line messages.
4 line LCD models:
Note: This screen presumes a printer capable of four line messages.
For each of the message lines, enter a number from 0 to 3 where 0 is the least print
density and 3 is the most.
When finished, press the ENTER key to store the changes in memory and exit the
line print density setting routine.
Adjusting the Speed
Use this option to match the speed of printing (the rate at which vertical lines in
the dot matrix are produced) to the speed of the conveyor. The faster the
conveyor, the faster the text must be printed in order to be legible. Speed
adjustment can be applied to one particular message or to all the messages in the
printer’s memory.
Note: The larger the speed value the longer the gap between printing the vertical lines in
the dot matrix.
Speed set too high
Dotsize 1 2
0...3 0 0
Dot size 1 2 3 4
0...3 0 0 0 0
To Next Page
Loading...
Need help?
General
