INSTALLATION
77091 Issue 2 November 2003 41
Connecting an Ink Bottle
In the photos on this page a one litre base is shown; follow exactly the same
procedure for the three litre base.
The ink cap is attached to the inside of the base unit by its two feed pipes (air in
and ink out). The two metal probes pierce the seal into the ink bottle allowing an
air-tight, ink-tight seal to be formed.
(1) If installing the printer for the first
time, there may be a piece of
protective tubing placed over the ends
of the probes. Pull off this piece of
tubing carefully - the probes are very
sharp. Check that both “O” ring
seals are present around the supply
stems, otherwise air and ink leaks may
occur.
WARNING: If replacing an empty ink bottle, remember to switch
the power off and press the pressure release valve
before unscrewing the old bottle.
(2) Discard the transit cap from the new
ink bottle and push the bottle into
place. In the one litre base it slots
down into the door of the unit. In
the three litre base it sits on the ledge
at the bottom of the unit.
To Next Page
Loading...
Need help?
General
