PROGRAMMING AND PRINTING
52 77091 Issue 2 November 2003
Note: Each message line can be up to 40 characters in length, including formatting codes -
refer to the FORMATTING MESSAGES chapter of this manual for further
information).
If there is already a message in the chosen location it will be displayed. To leave
the message without making any changes, press the ENTER key a second time. If
there is no existing message in the chosen location, a blank message screen will
appear. Type in the message using the keypad.
At the end of each message line, a marker will appear (a vertical line) indicating the
limit of entered text. To move to the next (or previous) line of a multi-line
message use the keys
These keys also allow the user to move to successive and previous messages (in
reference number order) held in the printer’s memory. As many messages as
required can be edited or created in one editing session. The following message
editing keys can also be used:
Enters a space
at the cursor
position.
Removes the character to
the left of the cursor
position. To delete the
last character in a line,
position the cursor over
the vertical marker.
Moves forward
through the
current message
line.
Clears the
contents of
the entire
current line.
Moves backward
through the
current message
line.
+
To Next Page
Loading...
Need help?
General
