Instructions for use BiliLux 51
Operation
The BiliLux can record up to three phototherapy sessions in one report, with each
session holding up to 30 entries. A fourth session will automatically overwrite the
oldest session. A session will end if one of the following occurs:
– Therapy is stopped by the user
– The device is turned off via the on/off switch
– The device loses power for more than 10 minutes
If the device is turned off or loses power, a report for the last three previously
recorded sessions can still be exported when power is restored (assuming the
stored values were not deleted during an earlier export).
8.6 Checking device status
The Device Status screen allows to user to check the total LED light usage in hours,
firmware version, date of last device inspection, and date of next device inspection.
1 Press the key repeatedly until the Device Status screen is displayed. The
screen shows the total LED light usage in hours (A), firmware version (B), and
an Inspect button (C).
2 Press the Inspect button. The screen shows the date of the last device
inspection (A) and the date of the next device inspection (B).
Press the Back button (C) to return to the previous screen.
Press the key (D) to exit the Device Status screen.
031032
To Next Page
Loading...
Need help?
General
