Dremel DIGILAB LC40 Operating And Safety Instructions

32
SETUP
Do not spill water on
the Hex Box™ unit.
Damage to electronics may occur.
1. Start the water pump by tapping the
Start Button on the Dremel LC40 Laser
Cutter’s LCD screen.
2. Using a funnel, fill the Hex Box™ with
distilled water until the Water Tank is
full, Fig. 21.
3. When the water level lowers, continue
adding distilled water to the Water
Tank until there are no visible bubbles
in the Laser Tube and water level in
the tank has stabilized at full.
4. When the tank is full, tap next button
to proceed to the stop water pump
screen.
5. Stop the water pump by pressing the
stop button on the Dremel LC40 Laser
Cutter’s LCD screen.
6. Screw on the Hex Box™ Cap.
Fill Hex Box™ with Distilled Water
AIR TUBE
TUYAU À AIR
TUBO D
E
AIRE
WATER IN
ENTRÉE D’EAU
ENTR
ADA DE
AGUA
WATER OUT
SOR
TIE D’EAU
SALIDA DE AG
UA
Hex
Box
12
V
Fig. 21
Fill
Line
Observe all provided warnings and safety instructions prior to and
when using the Dremel LC40 Laser Cutter. Failure to do so may
result in fire, equipment damage, property damage and/or personal injury, up to and
including death.
DM 1600A01CX8 08-18 LC40 EN.qxp_LC40 8/17/18 10:32 AM Page 32

Dremel DIGILAB LC40 Specifications

General

Brand	Dremel
Model	DIGILAB LC40
Category	Cutter
Language	English