5
LASER CUTTER SAFETY WARNINGS
the chassis and increase the risk of eye
injury.
Do not operate the laser machine with
any of the panels removed. Remember
that the laser beam is invisible!
Exposure of the laser beam will greatly
increase the risk of injury and/or fire.
Before using the laser machine, test the
ground fault circuit interrupter (GFCI)
provided with the supply cord to insure
it is operating correctly. A properly
operating GFCI reduces the risk of
electrical shock.
Do not attempt to modify or defeat the
safety interlock system for any reason.
This could result in exposure to
hazardous laser radiation.
Do not use laser cutter with extension
cords. The GFCI on the machine power
cord will not prevent electrical shock
from the extension cords.
Comply with all codes, regulations and
laws, including those for hazardous or
noxious exhaust ventilation systems.
Consult with federal, state and/or local
authorities and applicable homeowner
or condominium associations to ensure
compliance of ventilation and exhaust
systems. Failure to do so may result in
fire, equipment damage, property
damage and/or personal injury, up to and
including death.
Consult a qualified installer or service
agency for information or assistance if
installation of exhaust/venting is
beyond your skill level. Improper
installation, adjustment, alteration,
service, maintenance, or use can cause
fire, electric shock or other conditions
which may cause personal injury,
property damage or even death.
Maintain all manufacturer recommended
clearances during exhaust installation.
Failure to maintain proper clearances
could result in personal injury, death
and/or property damage.
Wear proper personal protective
equipment such as safety glasses,
protective clothing and work gloves
when performing exhaust connections.
Failure to do so may result in personal
injury.
Discontinue use and seek fresh air if
respiratory or eye irritation occurs.
Ensure ventilation, exhaust, and/or
filtration systems are working according
to manufacturer specifications and
make any necessary adjustments before
further use. Exposure to fumes may
cause allergy, asthma, breathing
difficulties or other adverse health
effects.
Always use provided work piece support
structure when cutting or scoring.
Fabrication without honeycomb plate
may lead to fire or release of stray
radiation.
Do not use irregularly shaped work
piece. Risk of stray radiation or fire.
Do not stack work pieces. Stacking work
pieces increases the risk of fire.
Use only recommended accessories.
Follow instructions that accompany
accessories. Use of improper accessories
may cause hazards
Ensure tools and parts such as spacer
puck, wrench, debris, etc. are removed
from the honeycomb plate before
starting a laser job. Objects or debris
may interfere with the laser head and
lead to stray radiation or risk of fire.
This product is provided with a GFCI
built into the power cord plug. If
replacement of the plug or cord is
needed, use only identical replacement
parts.
Do not try to clean exhaust ducting. The
high concentration of particles may
become airborne and create inhalation
exposure.
Do not spill water on the Hex Box™ unit.
Damage to electronics may occur.
Choice of material used during laser
cutter operation and subsequent health
consequences are the sole
responsibility of user. Health effects of
materials used may not be documented
nor available.
To Next Page
Loading...
Need help?
General
