Dremel DIGILAB LC40 User Manual

56
SETUP
Plug the Power Cord from the back of the
laser cutter into a grounded outlet.
Note: The Laser Cutter draws about 6.0
Amps at its maximum power. Be careful
not to connect too many other devices on
the same circuit. Make sure not to exceed
the current rating of the circuit.
Plug in the Laser Cutter
Test GFCI before each
use. Do not use
Dremel LC40 if the GFCI indicator does
not turn red after pressing the RESET
button. Take Dremel LC40 to a Dremel
authorized service center for repair.
Do not use laser cutter
with extension cords.
The GFCI on the machine power cord will
not prevent electrical shock from the
extension cords.
Test before each use. A
faulty GFCI can result in
electric shock.
The laser cutter is equipped with a GFCI
(ground fault circuit interrupter) unit
mounted on the cord, Fig 22.
1. Press ‘TEST’ button. Red should
disappear from the indicator window.
2. Press and release ‘RESET’ button. Red
should reappear in the indicator
window.
R
E
S
E
T
T
E
S
T
Reset
Test
Indicator
Test GFCI Unit
Fig. 22
Fig. 21
Observe all provided warnings and safety instructions when using
the Dremel LC40. Failure to do so may result in fire, equipment
damage, property damage or personal injury.

Dremel DIGILAB LC40 Specifications

General

Brand	Dremel
Model	DIGILAB LC40
Category	Cutter
Language	English