Ducati 999S User Manual

70
E
Chain tension inspection (fig. 64)
Important
Have the drive chain tensioned up at a Ducati
Dealer or Authorized Workshop.
With the motorcycle on the side stand, use your finger to
press down the chain lower section. Then release and
measure distance between surface (A) and pivot centre
below. The reading should be 30-35 mm.
Warning
Correct tightening of the tensioner lock nuts (1) is
essential to rider and pillion passenger’s safety.
Important
Improper chain tension will lead to early wear of
transmission parts.
Chain lubrication
The chain fitted on your motorcycle has O-rings that keep
dirt out of and lubricant inside the sliding parts. The seals
might be irreparably damaged if the chain is cleaned
using any solvent other than those specific for O-ring
chains or washed using steam or water jets. After
cleaning, blow the chain dry or dry it using absorbent
material and lubricate with SHELL Advance Chain or
Advance Teflon Chain on each link.
30 ÷ 35 mm
1
A
fig. 64
Important
Using non-specific lubricants may lead to severe
damage to chain, front and rear sprocket.

Ducati 999S Specifications

General

Displacement	998 cc
Transmission	6-speed
Rear Brakes	Single 240 mm disc, 2-piston caliper
Bore x Stroke	100 mm x 63.5 mm
Frame	Tubular steel trellis
Engine Type	L-twin, 4 valves per cylinder, Desmodromic
Front Suspension	Showa 43 mm fully adjustable upside-down fork
Rear Suspension	Fully adjustable Ohlins monoshock
Front Brakes	2 x 320 mm discs, 4-piston calipers
Fuel Capacity	15.5 liters
Fuel Injection	Marelli electronic fuel injection
Exhaust	2-1-2 system with catalytic converter
Torque	106 Nm @ 8, 000 rpm