81
5
2
1
Replacing Consumables
Replacing the Master Roll
The message “ROLL-MASTER END” is displayed on the LCD panel when the master roll is used up. Replace the
master roll using the following procedure.
• Only use a master roll designed for use in this machine.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Slide the scanner unit.
• Do not touch the heat generator of thermal
head. Doing so may cause damages, leading
to a malfunction of mastermaking.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Continue Page
•••
ROLL-MASTER END
Scanner unit
master holder
Lift out the master roll,then remove the master
holder from the master roll.
Pull out the master.
you while pushing the thermal head escape lever.
Turn off the power, pull out the master.
Master roll
IMPORTANT
IMPORTANT
Turn off the printer power, than turn the master holder toward
To Next Page
Loading...
Need help?
General
