EN
22 2016/11SE
30
31
32
16.2 Removing the container
• Lift the complete container vertically upwards
with one hand firmly holding the handle and
guide� With the other hand on the base of the
collector, guide the collector vessel upwards
so that it does not tilt while being lifted out�
• Release the engaging catches of the handle
to the collector� Pull the two catches outwards
so they are no longer holding onto the sides
of the cover and pull the handle carefully up-
wards� Remove the bacteria filter/excess vac-
uum stop from the handle section�
• Use both hands to remove the lid from the
collector� Remove the spray guard�
• Dispose of the contents of the collector as
appropriate�
16.3 Disinfection and cleaning
Use cleaning and disinfection devices strictly
according to manufacturer's instructions�
• Place the individual parts into the unit in such
a way that the interior surfaces will be rinsed
thoroughly and the water can drain off�
• Set up the cleaning and disinfection cycles
according to the manufacturer’s instructions�
• After the cleaning and disinfection cycles have
finished, carefully check the individual parts
for signs of residual dirt and repeat the cycles
if necessary�
To Next Page
Loading...
Need help?
General
