Eaton 9PX 1000i User Manual

Safety Instructions
Special Preventive Measures
• The unit is heavy: wear safety shoes and use vacuum lifter preferentially for handling operations.
• All handling operations will require at least two people (unpacking, lifting, installation in rack system).
• Before and after the installation, if the UPS remains de-energized for a long period, the UPS must be
energized for a period of 24 hours, at least once every 6 months (for a normal storage temperature less
than 25°C). This charges the battery, thus avoiding possible irreversible damage.
• During the replacement of the Battery Module, it is imperative to use the same type and number of
element as the original Battery Module provided with the UPS to maintain an identical level of
performance and safety. If there are any questions, don’t hesitate to contact your EATON representative.
• All repairs and service should be performed by AUTHORIZED SERVICE PERSONNEL ONLY. There are
NO USER SERVICEABLE PARTS inside the UPS.
• For potential safety issue on defective UPS : DISCONNECT INTERNAL BATTERY for storage and
transportation.

Eaton 9PX 1000i Specifications

General

Power Rating	1000 VA / 900 W
Output Voltage	230V
Input Voltage	230V
Output Power Factor	0.9
Nominal Voltage	230V
Frequency	50/60 Hz
Typical Recharge Time	3 hours
Operating Temperature	0-40°C
Operating Humidity	0-95% non-condensing
Battery Type	Sealed Lead Acid
Interface	USB
Input Voltage Range	176-276 V
User-selectable Output Voltage	200, 208, 220, 230, 240 V
Safety Approvals	CE, CB
Form Factor	Rack/Tower Convertible
Efficiency	Up to 98%