Eaton 9PX 1000i User Manual

HotSwap MBP module usage
The HotSwap MBP comes with a
knob with two gears:
Normal: The load power is
supplied by the UPS and the
indicator is on.
Bypass: The load power is
directly supplied by the AC
power source and the indicator
is on.
The UPS is powered on during the HotSwap MBP module configuration
1. Check whether the UPS is correctly connected to the HotSwap MBP.
2. Set the knob to the normal position.
3. Press the "On/Off" button on the UPS control panel to start the UPS.
The load has power supply from the UPS.
The "UPS ON- OK to switch" indicator of the HotSwap MBP is on.
HotSwap MBP module testing
1. Set the knob to the bypass position and check whether the load remains energized.
2. Set the knob to the normal position.

Eaton 9PX 1000i Specifications

General

Power Rating	1000 VA / 900 W
Output Voltage	230V
Input Voltage	230V
Output Power Factor	0.9
Nominal Voltage	230V
Frequency	50/60 Hz
Typical Recharge Time	3 hours
Operating Temperature	0-40°C
Operating Humidity	0-95% non-condensing
Battery Type	Sealed Lead Acid
Interface	USB
Input Voltage Range	176-276 V
User-selectable Output Voltage	200, 208, 220, 230, 240 V
Safety Approvals	CE, CB
Form Factor	Rack/Tower Convertible
Efficiency	Up to 98%