CONTROL OF REGENERATION VOLUMES
Four volumes of water are utilized for regeneration, totalling approximately 300 cc.
Depending on the type of dishwasher, regulation and exclusion of the regeneration system are performed in
different ways.
DW WITH ELECTROMECHANICAL TIMER
Regeneration is performed during every washing cycle.
REGULATION PROCEDURE
Five different levels of regeneration can be selected, each using a different quantity of water which is
controlled by the aperture or closure of a series of special valves.
The regeneration level is adjusted by turning a 5-position selector knob (located frontally in the upper
left-hand corner) until the mark is aligned with the desired level.
The appliance is factory-set to level 2.
LEVEL HARDNESS REGENERATION SALT VALVES
N° °F °D WATER CONS. CLOSED OPEN
1 8 - 25 4 - 14 25 cc 8 g A/B/C -
2 26 - 40 15 - 22 50 cc 15 g A/C B
3 41 - 60 23 - 34 90 cc 65 g B/C A
4 61 - 90 35 - 50 270 cc 75 g B A/C
5 91 - 120 51 - 70 300 cc 85 g - A/B/C
DW WITH ELECTRONIC TIMER
Regeneration is performed at predetermined intervals depending on the level selected (and not during every
washing cycle).
REGULATION PROCEDURE
Ten levels of regeneration can be selected, each of which utilizes a fixed quantity of water (300 cc) and salt
(85 g) for each regeneration cycle.
The level of regeneration is controlled electronically, and is entered by pressing a combination of keys on the
control panel.
The appliance is factory-set to level 4.
LEVEL REGENERATION HARDNESS TREATED
N° AUTONOMY INTERVAL °F °D
0 - (no regeneration) 0 - 8 0 - 4
1 9 cycles every 10 cycles 9 - 14 5 - 8
2 7 cycles every 8 cycles 15 - 20 9 - 11
3 5 cycles every 6 cycles 21 - 30 12 - 17
4 3 cycles every 4 cycles 31 - 40 18 - 22
5 2 cycles every 3 cycles 41 - 50 23 - 28
6 1 cycle every 2 cycles 51 - 60 29 - 33
7 0 cycles every cycle 61 - 70 34 - 39
8 0 cycles every cycle 71 - 80 40 - 45
9 0 cycles every cycle 81 - 120 46 - 70
- 22 -
To Next Page
Loading...
Need help?
General
