FUNCTIONAL CHARACTERISTICS OF THE CONTROL ORGANS
The functional characteristics of the programme are subdivided into three sequential phases:
- PROGRAMME SELECTION
- PROGRAMME EXECUTION
- END OF PROGRAMME.
A BUZZER sounds at different frequencies during each phase to indicate that the options selected have
been accepted.
The controls are positioned on the upper edge of the door. As a result, the door must be slightly ajar in order
to use or check the controls.
SETTINGS
SWITCHING ON
- Press the "ON/OFF" button to switch on the dishwasher, which passes to the Programme Selection
phase.
- Programme n° 1 is displayed on the DIGIT window.
- The "PROGRAMME SELECTION" LED flashes (and, if the salt requires topping up, the "SALT" LED
lights).
SELECTING THE "PROGRAMME"
- Press the programme selection button to select the desired programme. Each time this button is pressed,
the programme number increases by one.
- The BUZZER emits a short signal each time this button is pressed.
- At the same time, the selected porgramme (e.g. 2) is displayed on the DIGIT window.
- The "PROGRAMME SELECTION" LED continues to flash.
- The "WRD" LED lights automatically when programme n° 2 has been selected. For this programme, it is
advisable to introduce detergent for the pre-wash phase into the appropriate compartment of the "WRD"
dispenser.
SELECTING "ECO DRYING"
- When the "ECO DRYING" button is pressed, the hot-air drying phase is excluded.
- The "ECO DRYING" LED lights, and the BUZZER emits a short signal to confirm this option.
- If the LED is off, the drying phase for the specific programme is performed normally.
N.B. If the "ECO DRYING" option is selected, the HOT rinse is automatically replaced by a COLD rinse.
- 36 -
To Next Page
Loading...
Need help?
General
