SOI/DT 2005-01 dmm 14/67 599 36 82-57
8 Washing programmes
8.1.1 Configuration of the programmes
The table below lists the parameters that can be used to define the washing programmes.
Types of fabrics
Cotton/linen, Synthetics, Delicates, Wool, Hand-wash, Mini
Special programmes
Soak, Rinses, Spin, Drain, Conditioner
Temperature
Normal, Maximum: the initial temperature is the maximum that
can be selected for a specific washing programme
Spin
Normal, Minimum, Maximum
Options (Normal/Possible)
Bleach, Economy (energy label), Stains, Short, Very short,
Reduced spin speed, Night-time cycle, Half-load, Easy-Iron,
Rinse Hold, Extra rinse, Pre-wash, Sensitive, Intensive, No spin
Programme phases
Pre-wash, Wash, Rinses, Spin, End-of-cycle
8.2 Programme selector
The programme selector defines the type of washing cycle (ex: water level,
drum movement, no of rinses) and washing temperature to be selected
according to the type of wash.
The programme selector can be rotated both clockwise and anti-clockwise.
The first position is used to cancel the current programme (and to switch the
appliance off, if the main switch is incorporated in the selector).
8.3 Start/Pause
Start: after selecting the programme and the desired options, press this button to start. If the delay time has
been selected, the countdown will begin and the display will indicate it. The LED stops flashing and
remains lit for the whole duration of the programme.
Pause: by pressing the button again, the current programme is interrupted and the display or the
corresponding LED starts flashing. During the pause phase it is possible to open the door only if the
machine is not during the heating phase, the water level is not high and the drum is not moving.
During the pause it is possible to modify the programme as follows:
- the OPTIONS of the cycle can be modified before the phase by which they have to be performed
- the SPIN can be modified before the final spin
To re-start the programme press the START/PAUSE button again.
SELECTOR