SOI/DT 2005-01 dmm 599 36 82-57
51/67
11 DEMO Mode
A special cycle has been created for demonstration of the operation of these appliances in retail outlets
without connecting the appliance to the water supply. In this way, the salesman can select any programme;
after starting the cycle by pressing START, the appliance will perform certain phases only, and will skip
those which cannot be performed (water fill, drain, heating).
The cycle takes place as follows:
ª the door locking device is actioned in the normal way (i.e. the door remains locked while the appliance
is in operation, and can be opened at the end of the cycle or in pause mode)
ª motor: all low-speed movements are enabled, while the pulse signals and the spin cycle are excluded
ª the water fill solenoids and the drain pump are disabled
ª display: since the phases of the cycle take place in rapid succession (1 second of the demo cycle is
equivalent to 1 minute of the actual cycle), the time-to-elapse decreases by 1 unit per second.
Remember that the time-to-elapse does not always correspond to the actual cycle time
ª alarms: for reasons of safety, the following groups of alarms remain enabled: E40 (door closed), E50
and E90 (communication between the boards/configuration).
11.1 Exiting demo mode
ª Switch the appliance off to exit the demo mode.
1. Cancel the set programme and switch the appliance off.
2. Press the start/pause and exit buttons simultaneously, then, holding
them down, switch the appliance on rotating the programme selector of
two positions clockwise.
3. Hold the start/pause and option buttons down till DEMO MODE
appears (about 5 seconds).
To Next Page
Loading...
Need help?
General
