AGL_Sol_EV3_E_Rev_02 5
2.5 Conformity to directives and standards
The EV3 drive has been designed and developed especially for the European commercial market
based on applicable European Directives. The design is qualified by main safety standards
EN 60335-1 (Safety for household and similar electrical appliances, Part 1: General requirements),
EN 60335-2-34 (Part 2-34: Particular requirements for motor-compressor) and EN 60730-1
(Automatic electrical controls for household and similar use).
The EV3 drive complies with EMC standard EN 61800-3 Category C3. Depending on the unit design,
the drive may comply with Category C2 as well. However, if C2 cannot be achieved with the drive
alone, an external filter may be used. Recommended ferrites are shown in paragraph 3.4 "Electrical
installation".
Furthermore, the EV3 drive models comply with standard EN 61000-3-12 for harmonic currents
higher than 16 A. Further system-related requirements for compliance with the above-mentioned
standards are detailed in Chapter 3 "Installation".
2.6 Nomenclature
Table 5 hereunder explains the nomenclature based on the drive model EV3185B-K1-XXX.
Table 5: Nomenclature
2.7 Identification
The rating plate on the drive gives information about the drive, including model, serial number, rated
input and output, and certificate approval.
Figure 1: Rating plate
It is advised to check and confirm the rating plate before installing or operating the equipment.
To Next Page
Loading...
Need help?
General