Envoy Installation and Operation
2013 Enphase Energy Inc. 141-00011 Rev 05
10. Build the Virtual Array
When the system is energized and the Envoy detects at least one microinverter, create the virtual array in
Enlighten from the installation map you created.
You can scan and upload the paper copy of the Installation Map, or you can use the ArrayGun feature
from the Enphase Installer Toolkit to easily build and configure a system. Refer to
http://enphase.com/products/arraygun/ for more information.
To build the virtual array manually:
a. Log into Enlighten.
b. Use Array Builder to create the
virtual array in Enlighten.
c. Use your installation map as
your reference.
To see the Array Builder demo, go to
http://enphase.com/support/videos.
Once the virtual array is built, Enlighten
displays a graphic representation of the
PV system. It also shows detailed
current and historical performance
information.
11. View System Performance in Enlighten
Once the array is built and the system is activated, you can log in to Enlighten to view site data.
If you have not done so already, log in to Enlighten to view system data.
Refer to “How the Envoy Works with Enlighten” on page 27 for more information.
To Next Page
Loading...
Need help?
General
