Entrust Sigma DS2 User Manual

6 About the Printer
The Printer Cover
Use the cover latch handle to open the printer cover.
Input Hopper Lock The input hopper lock unlocks the input hopper. The lock is present
only in the DS3 printer models.
Reject Tray Unfinished cards or cards not processed properly are placed in the
reject tray. An administrator can change the reject card location to
the output hopper using the Printer Dashboard. Refer to the Printer
Dashboard Help for more information.
Printers without a reject tray always place unfinished cards in the
output hopper.
Printer Lock The printer lock unlocks the printer cover and reject tray. The lock is
present only in the DS3 printer models.
Printer Cover Open the printer cover to access the printhead and ribbon.
Cover Latch Handle Lift the latch handle to open the printer cover.
Cover Ridges Press down on the ridges when closing the cover to make sure that it
latches completely on both sides.
Cover Ridges
Cover Latch
Handle
Printer Cover

Entrust Sigma DS2 Specifications

General

Print Resolution	300 dpi
Card Capacity Input Hopper	125 cards
Card Capacity Output Hopper	25 cards
Connectivity	USB, Ethernet
Print Technology	Direct-to-card dye-sublimation / resin thermal transfer
Card Sizes	CR80
Operating System Support	Windows 7, Windows 8.1, Windows 10, Windows Server 2016, Windows Server 2012, Windows Server 2008
Card Thickness	0.010 inches to 0.040 inches (0.25 mm to 1.02 mm)
Print Speed	Up to 250 cards per hour (YMCKO)