8 About the Printer
Multi-Hopper Cartridge
The multi-hopper cartridges can be pulled out from the multi-hopper unit. You can remove the
cartridges with the cards inside and store them securely, if necessary.
Cartridge Release
Buttons
The cartridge release buttons allow you to remove the cartridge
from the multi-hopper unit. Push in the buttons, squeeze the
cartridge, and pull it out from the multi-hopper.
You do not need to remove a hopper cartridge to load cards.
Exception Slide The exception slide allows you to insert a single card into the printer
without unlocking the multi-hopper or opening a hopper cartridge.
Refer to “Use the Multi-Hopper Exception Slide” on page 28.
Cartridge Door
Release Button
The door release button allows you to open the cartridge door. Press
down on the release button.
Cartridge Door The cartridge door swings down to provide access to the cartridge to
load cards.
Card Weight The card weight maintains a downward pressure on the loaded cards
so that they enter the printer properly. Lift the card weight to the
top of the cartridge and gently pull it forward until it locks in
position. A diagram inside the cartridge shows how to position the
card weight and load cards.
Note: Do not place the cards on top of the card weight.
Label Retainer The label retainer allows you to insert a paper label inside the
cartridge door. Use a label to identify the cartridge number or the
type of cards loaded in each cartridge. Use a flathead screwdriver to
open the label retainer door.
Cartridge Door
Release Button
Cartridge
Door
Card Weight
Label Retainer
To Next Page
Loading...
Need help?
General
