EasyManuals Logo
Home>Epilog Laser>Engraver>FusionPro 16000

Epilog Laser FusionPro 16000 User Manual

Epilog Laser FusionPro 16000
242 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
- 18 -
SECTION 2: GETTING STARTED
Epilog Exhaust/Filter Connections
There are two 4” (102 mm) ports attached to the back of the Fusion Pro 32 laser system, and three 4” (102
mm) ports attached to the back of the Fusion Pro 48 laser system. The exhaust port on the Fusion Pro 32 is
approximately 14 ⁄ inches (368.3 mm) from the top of the machine, and the downdra port is approximately
32 ⁄ inches (825.5 mm) from the top of the machine. On the Fusion Pro 48 the exhaust ports are approximately
13 ⁄ inches (349.25 mm) from the top of the machine, and the downdra port is approximately 34 ⁄ inches
(876.3 mm) from the top of the machine. Attach your ducting to the machine as shown in the diagram.
Check your exhaust system for leaks. Most small leaks can be remedied with duct tape.
DO NOT OPERATE your laser with inadequate or leaking exhaust.
The drawings above show the typical exhaust setup. The le drawing shows the exhaust near the machine
and the right drawing shows the exhaust fan on the roof. Where the exhaust fan is placed is a choice of
personal preference. Some users like the exhaust fan outside because of noise considerations.
Roof or Exterior Wall
4” (102 mm) flexible
aluminum duct or
rigid galvanized
sheet metal (do
not use vinyl,
plastic or “so”
flexible duct).
Exhaust Blower
Roof or Exterior Wall
Exhaust Blower
4” (102 mm) flexible aluminum
duct or rigid galvanized sheet
metal (do not use vinyl, plastic
or “so” flexible duct).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epilog Laser FusionPro 16000 and is the answer not in the manual?

Epilog Laser FusionPro 16000 Specifications

General IconGeneral
BrandEpilog Laser
ModelFusionPro 16000
CategoryEngraver
LanguageEnglish

Related product manuals