Epiroc FlexiROC T20 R User Manual

59
Operator's instructions
4. Controls
Replacing the box
Use the learn link routine for replacing the radio box.
Learn link connects transmitter (radio box) with receiver (rig). After the procedure, the rig
addresses to the new radio box.
Learn-link
1. Switch off the rig with the main power contactor (S300) and switch off the radio box.
Connect in accordance with the figure below. Connect the radio box via Learn-link cable (9106
9715 24) to KC21 on the A1-cabinet.
2. Activate the main power contactor (S300) to the ON position (I).
3. Start the radio box in learn-link mode by depressing buttons (5) and (10) simultan- eously
until the "Start learn-link" image is shown on the display.
Start the radio box in learn-link mode

Epiroc FlexiROC T20 R Specifications

General

Brand	Epiroc
Model	FlexiROC T20 R
Category	Construction Equipment
Language	English