77
Operator's instructions
5. Operating
1.
The cable must run in line with the eye on the connector sleeve.
2.
The rope lock must only lock the end cable.
3.
The free end must be at least 6-9 x the diameter of the cable in order to ensure that the
whole section of the cable that is either lashed-in or annealed and tapered is out- side
the connector sleeve.
Tramming uphill
Risk from dumping and moving parts
May cause serious personal injury and damage to
property
The angles for Downward/Upward/Lateral CANNOT be
combined with each other
Do not exceed the inclination angles, See technical
data
Note the gradient meters' values
Never operate the drill rig from the down side
Keep the winch cable continuously taught
1.
Activate the remote control box (see chapter: Activating the remote control box).
2.
Check that the remote control box is in tramming mode. Switch (2), position c.
3.
Disengage the winch drum with the disengagement mechanism (A) to enable the cable
to be pulled out.
Disengagement mechanism, winch
To Next Page
Loading...
Need help?
General
