Epiroc FlexiROC T20 R User Manual

64
Operator's instructions
5. Operating
Diesel engine starting
NOTE: Monitor pressure gauges and display for diesel engine when in operation.
1. Check that the ignition switch S139 (ignition key) is in position (I). Wait until diesel engine
preheating is finished and indicator lamp H273 has extinguished.
2. Start the engine with touch button (13).
Touch buttons
NOTE: NOTICE! If the engine does not start, stop the starting procedure after 5 seconds.
NOTE: If a fault is indicated by the indicator lamps on the radio box or the diesel panel for the diesel engine: switch
off the engine and check to see which symbol(s) is/are illuminated and then rectify the fault.
When the engine is warm, with the knob 4 in tramming mode and pushing the button S331
on the electrical box you will activate the automatic pre-heating until the hydraulic oil will
reach 35°C. You can deactivate it by turning the knob in positioning or drilling mode.

Epiroc FlexiROC T20 R Specifications

General

Brand	Epiroc
Model	FlexiROC T20 R
Category	Construction Equipment
Language	English