81
Operator's instructions
6. Before drilling
1. Set the remote control box in tramming and positioning mode. Switch (2), position
(c).
Remote control box
2. Set up the rig horizontally using the jacks. Switch (10) in position (c) and switch (7) in
position (a).
Correct set up for drilling
3. Set the remote control box in drilling mode. Switch (2), position (b).
4. Position the feed beam and boom to the desired position. Set the feed spike firmly
against the ground without lifting the drill rig. Right and left-hand multifunction lever.
NOTE: Do not lift the drill rig with the feeder!
To Next Page
Loading...
Need help?
General
