EasyManuals Logo
Home>Epson>Projector>EH-TW7100

Epson EH-TW7100 User Manual

Epson EH-TW7100
112 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #79 background imageLoading...
Page #79 background image
Troubleshooting
78
Projection stops automatically
Check Remedy
Is Sleep Mode enabled?
If the set time is exceeded and no signal is input, the lamp is
automatically turned off and the projector enters standby mode.
Press the power button on the remote control or the standby
button on the control panel to turn on the projector. If you want
to disable Sleep Mode, change the setting to Off.
s Exten-
ded - Operation - Sleep Mode p.65
Noise problems
No audio, or the audio is too low
Check Remedy
Is the audio cable connected correctly? Try disconnecting the cable from the Audio Out port, and then
reconnecting.
Is the volume too low? Adjust the volume so that you can hear the audio.
s p.33
Is it connected with an HDMI cable? If no audio is output when connecting via an HDMI cable, set the
connected equipment to PCM output.
Are the Audio Out Device settings correct? Check that the Audio Out Device settings are correct on the
Configuration menu.
s Settings - HDMI Link - Audio Out De-
vice p.62
Are the Bluetooth Audio settings correct?
Make the following settings when connecting a Bluetooth audio
device.
To output audio from the projector's speaker or an AV system,
set Bluetooth Audio to Off.
To output audio from Bluetooth audio devices, set Bluetooth
Audio to On.
s Settings - Bluetooth - Bluetooth Audio p.62
Problems when projection starts
The projector does not turn on
Check Remedy
Is the power turned on? Press the power button on the remote control or the standby
button the control panel to turn on the projector.
Is Child Lock set to On? When Child Lock is set to On from the Configuration menu, hold
down the standby button on the control panel for approximately
three seconds, or perform operations from the remote control.
s Settings - Lock Setting - Child Lock p.62
Do the indicators turn on and off when the
power cord is touched?
Turn off the projector, and then disconnect and reconnect the
projector's power cord. If the problem continues, stop using the
projector, remove the power plug from the electrical outlet, and
contact your local dealer or the nearest projector information
center.
s Epson Projector Contact List

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson EH-TW7100 and is the answer not in the manual?

Epson EH-TW7100 Specifications

General IconGeneral
Matrix size0.61 \
Number of colors1.07 billion colors
Native aspect ratio16:9
Projection distance2.95 - 4.77 m
Vertical scan range192 - 240 Hz
Projection technology3LCD
Contrast ratio (typical)100000:1
Screen size compatibility40 - 500 \
Projector native resolution2160p (3840x2160)
Keystone correction, horizontal-30 - 30 °
Lamp typeUHE
Lamp power250 W
Light source typeLamp
Service life of light source3500 h
Service life of light source (economic mode)5000 h
FocusManual
Throw ratio1.32 - 2.15:1
Zoom capabilityYes
Focal length range18.2 - 29.2 mm
Aperture range (F-F)1.49 - 1.77
Vertical lens shift range-60 - 60 %
Horizontal lens shift range-24 - 24 %
PlacementCeiling, Desktop
Product typeStandard throw projector
Product colorWhite
Market positioningHome cinema
Cable lock slot typeKensington
Built-in displayNo
Video processing10 bit
Video color modesAuto, Cinema, Dynamic, Natural, Bright cinema
Supported 3D formatsSide by side, Top and bottom
Supported video modes2160p
Supported 3D technologiesSamsung Active 3D
Analog signal format system-
Supported graphics resolutions3840 x 2160
Power sourceAC
AC input voltage100-240 V
AC input frequency50 - 60 Hz
Power consumption (standby)0.5 W
Power consumption (typical)387 W
Power consumption (PowerSave)297 W
Audio (L/R) out1
Serial interface typeRS-232C
USB 2.0 ports quantity2
VGA (D-Sub) ports quantity0
Noise level32 dB
Country of originPhilippines
2D/3D frequency image240/480 Hz
Noise level (economic mode)24 dB
Storage temperature (T-T)-10 - 60 °C
Operating temperature (T-T)5 - 30 °C
Storage relative humidity (H-H)10 - 90 %
Operating relative humidity (H-H)20 - 80 %
RMS rated power10 W
Pallet weight0 g
Quantity per pack1 pc(s)
Quantity per pallet18 pc(s)
Quantity per pallet (UK)36 pc(s)
Harmonized System (HS) code85286200
Weight and Dimensions IconWeight and Dimensions
Depth310 mm
Width410 mm
Height157 mm
Weight6900 g
Package depth500 mm
Package width495 mm
Package height235 mm
Package weight8947 g

Related product manuals