Placing Documents in the
Scanner
Failure to observe the following precautions when
placing the original in the scanner may result in reduced
print quality or scanning failures.
❏ DS-530 is a scanner that scans both sides
simultaneously but it cannot scan both sides of the
document with enlarged copying. Place the side you
want copying facing downward in the ADF.
❏ Be sure to insert the original in landscape (wide)
orientation.
❏ If there are documents both on the glass and in the
ADF, the document in the ADF will be scanned.
Remove documents from the ADF before placing a
document on the glass.
❏ The ADF can not be used when:
❏ When JIS B1 or A0 is selected for Reduce/
Enlarge and multiple copies will be made
❏ The original is printed on thick stock (e.g.,
postcards or photographs)
❏ When multiple copies are made from an original
placed on the glass, the original may be scanned
once for each copy.
Wait until all the copies have been printed before
opening the scanner cover.
❏ Use the ADF to scan multi-page documents.
❏ If multiple copies are set for scanning multiple
sheets continuously, the copies will be printed on a
page basis as shown below.
Example: Order in which pages are output when the
printer is used to make two copies of a two page
document
SC-T5400 Series/SC-T5400M Series/SC-T3400 Series/SC-T3400N Series User's Guide
Making Enlarged Copies with an A3 or A4 Scanner (SC-T5400 Series/SC-T3400 Series/SC-T3400N Series Only)
113
To Next Page
Loading...
Need help?
General