D
Loosen the screw holding the cutter in place
using a cross-head screwdriver and pull the
cutter straight out.
Note:
Place the used cutter in a plastic bag, then dispose of
in accordance with regional ordinances, and as
directed by local government.
E
Install the new cutter.
Insert the cutter so that the pin on the printer
matches up with the hole on the cutter. Use a
cross-head screwdriver to tighten down the
screw to hold the cutter in place.
c
Important:
Screw the cutter firmly, otherwise the cut
position may be slightly shifted or skewed.
F
Touch OK.
The cutter returns to its original position, and the
protective sheet inserted in the cutter comes out.
Remove the protective sheet.
SC-T5400 Series/SC-T5400M Series/SC-T3400 Series/SC-T3400N Series User's Guide
Maintenance
190
To Next Page
Loading...
Need help?
General