Touch the (Cut) button.
The paper is cut.
Note:
When the length of
in the figure is shorter than
the following length, the paper is fed automatically
until the required length is obtained at the time of
cutting.
❏ Plain paper or tracing paper: 100 mm
❏ Photo paper or coated paper: 80 mm
❏ Synthetic paper and other thick paper: 60
mm
Cutting Commercially Available
Synthetic or Canvas Paper with
Scissors
When using commercially available paper that cannot
be cleanly cut with the cutter of the printer, print cut
lines and cut the paper with scissors.
c
Important:
❏ If commercially available synthetic or canvas
paper is cut with the built-in cutter, the cutter
may be damaged or its life may be shortened.
When using such paper, cut the paper with
scissors as described in the following procedure.
❏ Do not use a cutter. The printer may be
damaged.
A
Turn off the auto cut setting and then print.
To print cut lines, turn off the auto cut setting of
the printer. When printing via the printer driver,
also turn off the setting of the printer driver.
❏ Printer settings
Roll paper information area - Advanced Media
Setting - Auto Cut - Off from the Home
screen.
❏ Printer driver settings
Advanced - Roll Paper Option - Auto Cut -
Off
B
Touch the Roll paper information area - Feed/
Cut Paper from the Home screen of the printer
after printing finishes.
C
Operate the buttons displayed on the screen.
When printing cut lines at the printer default
position (right after the bottom margin)
Touch the
(Cut) button. The cut or print cut
lines selection screen appears.
SC-T5400 Series/SC-T5400M Series/SC-T3400 Series/SC-T3400N Series User's Guide
Loading and Setting the Paper
39
To Next Page
Loading...
Need help?
General