SUPPLEMENTARY OPERATING MANUAL 2
2-
4
05-19-06 CDP-01 Figure Sheet 1-900
AUTOMATIC
’Automatic’
Select ‘Automatic’ via external control.
The panel is set to drive 3.
The sensor mode is set to Edge Right.
The sensor positioner drive is switched to Automatic.
The sensor searches for the web edge.
INPUTS I5 I4 I3 I2 I1 I0
STATUS - L H L L -
When the web edge is detected, if Auto Permissive is
selected via external control, the sensor will continue to
follow the edge of the web until Automatic is selected.
INPUTS I5 I4 I3 I2 I1 I0
STATUS - H H L L -
If Automatic is selected, the positions of the sensor
positioner and the mandrel are recorded.
The mandrel drive is switched to Automatic. The
mandrel now follows the position of the sensor
positioner.
The guide point or system gain can be altered, if
desired.
Reference: CDP-01 Reference Manual, ‘Basic Settings’
section.
To Next Page
Loading...
Need help?
General