PRINCIPLE OF OPERATION
The system makes it easier to pull away
when the vehicle is on a slope without the
need to use the parking brake.
When the system is active, the vehicle will
remain stationary on the slope for a short
time after you release the brake pedal.
During this time, you have time to move
your foot from the brake to the
accelerator pedal and pull away. The
brakes are released automatically once
the engine has developed sufficient drive
to prevent the vehicle from rolling down
the slope. This is an advantage when
pulling away on a slope, for example from
a car park ramp, traffic lights or when
reversing uphill into a parking space.
WARNING
The system does not replace the
parking brake. When you leave the
vehicle, always apply the parking
brake and select first or reverse gear.
USING HILL START ASSIST
The system is activated automatically
when you stop your vehicle on a slope
greater than 3%. The system operates
with the vehicle facing downhill if reverse
gear is selected and with the vehicle
facing uphill if any forward gear is
selected.
To set the system mode:
Vehicles with manual transmission
only
You can access the menu using the
Information display control. For item
location: See Quick start (page 10).
1. Press the right arrow button on the
steering wheel to enter the main
menu.
2.
Highlight Setup with the up and down
buttons and press the right arrow
button.
3.
Highlight Hill Start and press the right
arrow button.
4. Select the desired setting and press
the OK button to confirm the setting.
5. Press the left arrow button to exit the
menu. To return to the trip computer
display directly, hold the left arrow
button pressed.
Activating the system
WARNINGS
You must remain in the vehicle once
you have activated the system.
At all times you are responsible for
controlling the vehicle, supervising
the system and intervening, if
required.
If a malfunction is detected when
the system is active, the system will
be deactivated and a message will
be shown in the display. See
Information messages (page 90).
You can activate the system only if the
following conditions have been met:
•
The engine is running.
•
The system is switched on.
•
On vehicles with manual transmission,
the clutch pedal is pressed.
•
No failure mode is present.
To activate the system:
1. Press the brake pedal to bring the
vehicle to a complete standstill. Keep
the brake pedal depressed.
145
Hill start assist
To Next Page
Loading...
Need help?
General
