Reduced guard
In reduced guard, the interior sensors are
deactivated when you arm the alarm.
Note:
You can set the alarm to reduced
guard for the current ignition cycle only.
The next time you switch on the ignition,
the alarm will be reset to full guard.
Ask on Exit
You can set the information display to ask
you each time which level of guard you
wish to set.
If you select Ask on Exit, the message
Reduced guard? appears in the
instrument cluster display each time you
switch the ignition off.
If you wish to arm the alarm with reduced
guard, press the OK button when this
message appears.
If you wish to arm the alarm with full guard,
leave the vehicle without pressing the OK
button.
Selecting full or reduced guard
Note:
Selecting Reduced does not set
the alarm permanently to reduced guard.
It sets it to reduced guard only for the
current ignition cycle. If you regularly set
the alarm to reduced guard, select Ask
on Exit.
1. Press the right arrow button on the
steering wheel to enter the main
menu.
2.
Highlight Setup with the up and down
arrow buttons and press the right
arrow button.
3.
Highlight Alarm and press the right
arrow button.
4.
Highlight Reduced or Full guard. If
you prefer to be asked each time you
switch off the ignition, select Ask on
Exit.
5.
Press the OK button to confirm the
selection.
6. Press the left arrow button to exit the
menu. To return to the trip computer
display directly, hold the left arrow
button pressed.
Information messages
See Information messages (page 90).
ARMING THE ALARM
To arm the alarm, lock the vehicle. See
Locks (page 38).
48
Alarm
To Next Page
Loading...
Need help?
General
