Using the System
Use the steering wheel controls to operate
the system.
Set speed increaseA
Set speed decreaseB
On and offC
Gap increaseD
Gap decreaseE
Cancel and resumeF
Switching the System On
Press switch C. The system is set to
standby mode.
Setting a Speed
Note: The system must be in standby
mode.
Press switch A or B to select your desired
cruise speed. The speed is displayed in the
information display and stored as the set
speed.
Changing the Set Speed
Note: Vehicle speed may be increased and
decreased at intervals of 5 mph or 5 km/h
depending on your unit of measure setting.
Note: If the system does not react to these
changes the reason may be that the gap
interval to the vehicle in front of you
prevents an increase in speed.
Press switch A to increase or switch B to
decrease the set speed until the desired
set speed is shown in the information
display. Your vehicle speed will gradually
change to the selected speed.
Setting the Vehicle Gap
Note: Use the appropriate gap setting in
accordance with local traffic regulations.
Note: The gap setting is time dependent
and therefore the distance will
automatically adjust with your speed. For
example on a gap setting of four bars, the
time gap is 1.8 seconds. This will mean that
at a speed of 62 mph (100 km/h), the
distance to the vehicle in front of you will
be maintained at 164 feet (50 meters).
Note: If you depress the accelerator for a
short period of time, for example when
overtaking, the system will temporarily
switch off. It will switch back on when you
release the accelerator pedal. A message
will be shown in the display.
Note: The gap setting will remain
unchanged each time you switch the ignition
on.
145
Kuga (CBS) Vehicles Built From: 10-03-2014, Vehicles Built Up To: 31-12-2014, CG3585en enGBR, Edition date: 02/2014, None
Cruise Control
To Next Page
Loading...
Need help?
General
