Fuji Xerox DocuCentreS2320 User Manual

8 Tools
142
Tools
8
Region & Timer Settings
Region
Sets the machine's region of use.
You can select from [Australia], [China], [Taiwan], [Hong Kong], [Indonesia], [Korea],
[Malaysia], [New Zealand], [Philippines], [Singapore], [Vietnam], or [Thailand].
[Australia] is set at the time of factory shipment.
Important • If you change the [Region] setting after you have started using the machine, all the settings will be
reset. Change the [Region] setting with care.
Follow the steps below to make the settings.
1 In the [Region & Timer Settings] screen, select
[Region].
2 Press the <OK> button.
3 Select your region, and then press the <OK>
button.
4 Select [Yes (Restart Required)], and then press
the <OK> button.
Restart the machine (turn the power OFF and
then turn it back ON again).
Auto Reset Timer
Sets the amount of time the machine waits before automatically returning to the Default
Display screen when no operation is being performed.
You can select [15 seconds], [30 seconds], [45 seconds], [1 minute], [2 minutes], [3 minutes],
or [4 minutes].
[45 seconds] is set at the time of factory shipment.
Auto Print Timer
Used to set the amount of time the machine waits after operating the control panel, loading
paper on the document feeder, or closing a tray until starting to print automatically.
You can set a value between 1 and 240 seconds (in 1 second increments).
[10 seconds] is set at the time of factory shipment.
Power Saver Timer
Used to make settings for the Power Saver function.
 Low Power Mode
Sets the amount of time the machine waits before entering Low Power mode.
You can set a value between 1 and 60 minutes (in 1 minute increments).
Auto Reset Timer ... 45 seconds
Region & Timer Settings
Region
... Australia
Auto Print Timer ... 10 seconds
China
Taiwan
Region
Australia
Yes (Restart Required)
Apply Settings [Are You Sure?]
No

Fuji Xerox DocuCentreS2320 Specifications

General

Brand	Fuji Xerox
Model	DocuCentreS2320
Category	Printer
Language	English