7.10 Adjusting the Image Transfer Voltage 165
7.10 Adjusting the Image Transfer Voltage
When you have unsatisfactory printing results, such as having white spots on the printed
image, having extra toner spilt on the printout, or a bluish printout, adjust the image transfer
voltage to solve these printing problems.
The image transfer voltage can be adjusted for each paper type within the range of -6 to 6
in increments of 1. The default is “0”.
Use the following procedure to adjust the image transfer voltage.
1. Press the <Menu> button on the control
panel to display the menu screen.
2. Press the < > button until [Admin Menu] is
displayed.
3. Press the < > or <Eject/Set> button to
accept the selection.
[Wired Network] is displayed.
4. Press the < > button until [Maintenance
Mode] is displayed.
5. Press the < > or <Eject/Set> button to
accept the selection.
[Adjust PaperType] is displayed.
6. Press the < > button until [Adjust BTR] is
displayed.
7. Press the < > or <Eject/Set> button to
accept the selection.
[Plain Paper] is displayed.
8. Press the < > button until the paper type
you want to set is displayed.
(Example: Recycled Paper)
9. Press the < > or <Eject/Set> button to
accept the selection.
A screen that allows you to enter the value
is displayed.
10. Press the < > or < > button to set the
value, then press the <Eject/Set> button.
(Example: 1)
11. Press the <Menu> button to return to the
print screen.
Menu
Report / List
Menu
Admin Menu
Admin Menu
Wired Network
Admin Menu
Maintenance Mode
Maintenance Mode
Adjust PaperType
Maintenance Mode
Adjust BTR
Adjust BTR
Plain Paper
Adjust BTR
Recycled Paper
Recycled Paper
0 *
Recycled Paper
1 *
To Next Page
Loading...
Need help?
General
