164 Using the Operator Panel Menus
Meter Readings
Use Meter Readings to check the total number of printed pages.
Admin Menu
Use the Admin Menu to configure a variety of printer features.
NOTE:
• A password is required to use the Admin Menu when Panel Lock Set is set to Enable. In this case, enter
the password you specified, and press the button.
Network
Use the Network option to change the printer settings affecting jobs sent to the printer through the
network.
•Ethernet
Purpose:
To specify the communication speed and the duplex settings of Ethernet. To make any changes
effective, turn off the printer and then turn it back on.
Values:
NOTE:
• This menu item appears only when the printer is connected to a wired network.
• Wi-Fi Status (DocuPrint P255 dw only)
Purpose:
To display the information on the wireless signal strength. No changes can be made on the operator
panel to improve the status of the wireless connection.
Values:
NOTE:
• This menu item appears only when the printer is connected to a wireless network.
Auto* Detects the Ethernet settings automatically.
10BASE-T Half Uses 10base-T half-duplex.
10BASE-T Full Uses 10base-T full-duplex.
100BASE-TX Half Uses 100base-TX half-duplex.
100BASE-TX Full Uses 100base-TX full-duplex.
* Factory default menu setting
Good Indicates good signal strength.
Acceptable Indicates marginal signal strength.
Low Indicates insufficient signal strength.
No Reception Indicates that no signal is received.
To Next Page
Loading...
Need help?
General
