260
Peripherals and Optional Accessories
10
BUILT-IN FLASH
The following options are
available with the built-in
ash.
MODE
Built-In Flash
ADJUST
END
Setting
Description
A
Flash control
mode
Choose from the following options:
•
TTL: TTL mode. Adjust fl ash compensation (
B
)
and choose a fl ash mode (
C
).
•
M: The fl ash fi res at the selected output (
B
) re-
gardless of subject brightness or camera settings.
Output is expressed in fractions of full power,
from ⁄ to ⁄. The desired results may not be
achieved at low values if they exceed the limits
of the fl ash control system; take a test shot and
check the results.
•
C (COMMANDER): Choose if the fl ash is being
used to control remote synced fl ash units, for ex-
ample as part of a studio fl ash system.
•
OFF: The fl ash does not fi re.
B
Flash compen-
sation/output
Adjust fl ash level. The options available vary with
the fl ash control mode (
A
).
To Next Page
Loading...
