94
5
Taking Photographs
Flash Settings
The following settings are available with the built-in ash.
ADJUST
END
ODE
Built-In Flash
Setting
Description
A
Flash control mode
Choose from the following options:
•
TTL: TTL mode. Adjust fl ash compensation (
B
) and choose
a fl ash mode (
C
).
•
M: The fl ash fi res at the selected output (
B
) regardless of
subject brightness or camera settings. Output is expressed
in fractions of full power, from ⁄ to ⁄. The desired results
may not be achieved at low values if they exceed the limits
of the fl ash control system; take a test shot and check the
results.
•
C (COMMANDER): Choose if the fl ash is being used to con-
trol remote synced fl ash units, for example as part of a stu-
dio fl ash system.
•
D (OFF): The fl ash does not fi re.
B
Flash compensation/
output
Adjust fl ash level. The options available vary with the fl ash
control mode (
A
).
To Next Page
Loading...
Need help?
General
