− 40/83 −
9-2. Changing the Setup
This section explains how to setup the printer without using a PC.
Alternatively, when the printer is connected to a Windows PC, the settings can
be changed using the utility software on the enclosed CD.
For instructions on installing and using the utility software, refer to the
"Installation Guide" and "Utility User's Guide" located in the
\Manual\Software\English folder of the CD.
• Installation Guide : FP1000_InstallGuide1_en.pdf
• Utility User's Guide : FP1000_UtilityGuide_en.pdf
The "Installation Guide" and "Utility User's Guide" can also be viewed by
loading the CD in your PC’s CD drive and selecting "Manuals" on the
"Thermal Printer Setup" screen that appears.
Setting Example Select a higher print density
Print Density Changed from 100% to 130%
Perform setup as follows:
1. Check the printer state prior to setting.
(1) The power is off.
(2) The paper roll is set.
(3) The cover is closed.
To Next Page
Loading...
Need help?
General